One used Hypoid Lapper

Capacity

Maximum Gear Diameter..........................10-1/2"

Maximum Pinion Diameter...............................6"

Offset of gear spindle above or below

center of pinion Spindle(max).....................3-3/4"

Pinion Spindle

Diameter of taper hole at large end............3-29/32"

Taper per foot.......................................39/64"

Depth of Taper............................................3"

Diameter of hole through Spindle.................2-1/2"

Gear Spindle

Diameter of taper hole at large end............2-19/64"

Taper per foot............................................½"

Depth of Taper............................................3"

Diameter of hole through Spindle................2-3/16"

Electrical Equipment

Main Motor...............................................5HP

Hydraulic Pump........................................¾ HP

Lapping compound pump motor......................1HP

Oscillating drive motor...............................¼ HP

Miscellaneous

Floor Space................................71" x 64" x 67"H

Weight (approximate)..........................9,250 LBS